![]() ![]() IP protocol = 51 → Used by data path (AH) IP protocol = 50 → Used by data path (ESP) ![]() Specified the User-Defined Original IP field and Type the translated destination IP address that this NAT rule supports.Ģ. IP forwarding must be enabled at the firewall for the following IP protocols and UDP ports: Set Up the NAT Router (Using ZyWALL USG device in this example)ġ. Select the Incoming Interface on which packets for the NAT rule must be received. Then, type a secure Pre-Shared Key (8-32 characters). Click Next.Ĥ. Configure Secure Gateway IP as the Branch’s WAN IP address (in the example, 172.100.20.30). You may use 1-31 alphanumeric characters. Click Next.ģ. Type the Rule Name used to identify this VPN connection (and VPN gateway). Set Up the ZyWALL/USG IPSec VPN Tunnel of Corporate Network (Branch)ġ. In the ZyWALL/USG use the VPN Settings wizard to create a VPN rule that can be used with the FortiGate. Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings > Wizard Completedħ. Configure Peer ID Type as Any to let the ZyWALL/USG does not require to check the identity content of the remote IPSec router.ĬONFIGURATION > VPN > IPSec VPN > VPN Gateway > Show Advanced Settings > Authentication > Peer ID Type Phase 2: VPN > IPSec VPN > VPN Connection The Phase rules settings will appear in here Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings (Summary)Ħ. Now the rule is configured on the ZyWALL/USG. Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings (Configuration)ĥ. This screen provides a read-only summary of the VPN tunnel. Set Local Policy to be the IP address range of the network connected to the ZyWALL/USG (HQ) and Remote Policy to be the IP address range of the network connected to the ZyWALL/USG (Branch). Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings (Scenario)Ĥ. Configure Secure Gateway IP as the Branch’s WAN IP address (in the example, 172.100.30.40). Quick Setup > VPN Setup Wizard > Wizard Typeģ. Type the Rule Name used to identify this VPN connection (and VPN gateway). Set Up the ZyWALL/USG IPSec VPN Tunnel of Corporate Network (HQ)ġ. In the ZyWALL/USG use the VPN Settings wizard to create a VPN rule that can be used with the FortiGate. Click Next.Ģ. Choose Express to create a VPN rule with the default phase 1 and phase 2 settings and use a pre-shared key to be the authentication method. When the IPSec Site to Site VPN tunnel is configured, each site can be accessed securely. The example instructs how to configure the VPN tunnel between each site while one Site is behind a NAT router (a.k.a. This example shows how to use the VPN Setup Wizard to create an IPSec Site to Site VPN tunnel between ZyWALL/USG devices. ![]()
0 Comments
Leave a Reply. |